Need advice on RCI 2995dx repair.

Hello all. I've pulled a major screw up on my 2995. I was going over the alignment procedure - specifically, I was checking the Driver and Final mA settings and when I went to remove the test lead (aligator clip) from TP7, I accidently shorted TP7 to ground. A small puff of smoke from, or near, Q66 and the radio no longer transmits. All other functions, including receive, seem to be unaffected by the short.

This is the later model 2995dx with board revision EPT695015A. It's an SMT board,...

Need advice on RCI 2995dx repair.